Please sign in so that we can notify you about a reply
Short description:
This RTD TC temperature signal conditioner for RTD sensors, potentiometers, resistors and thermocouples monitors and reports signals for up to two switching thresholds. The sensor and status information that is collected is also made available to a higher-order device (e.g., a PLC) via a bus connection.
Features:
- A relay with changeover contact reacts to configured measurement range limits (on/off switching delay and threshold value switch function can be configured with up to two threshold values)
- Configurable Pt factor
- Adjustable software filter
- Simulation of input/output response via interface configuration display
- Input of customer-specific sensors via the interface configuration software
- Safe 3-way isolation with 3 kV test voltage per EN 61010-1
- Output-end RS-485 interface with Modbus protocol
- Terminating resistor can be adjusted at the output
- Adjustable transfer characteristic
Notice:
The device is supplied with 24 VDC, which can be commoned using lateral push-in type jumper bars: (6.1) US+ (BR) and (6.2) GND 2 (BR). With this variant, it is necessary to ensure that the max. permissible total current of 1 A is not exceeded.
Σήμα Εισόδου:
- Temperature (RTD/TC etc)
- Resistance-Potentiometer
Σήμα Εξόδου:
- Modbus RTU
Specialty Functions:
- Relay Output
- Simulation